May want to check your Pro for this throttle cable rub spot

[akmclean]

Found this wear spot while I had my hood off today. The throttle cable is rubbing on the main wiring harness that goes to the tach and lights. My sled only has 250 miles and the cable already wore in to the wire insulation. A couple more hundred miles and it would have been into the metal.

This may have been covered previously. If so, I appologize

 

[frontierfire]

Nice find I will check mine, thanks

 

[The Fourth Wolf]

Good catch!

 

[akrevrider]

I took a look at my Pro's throttle cable and it is zip tied to the CF support tube with a rubber grommet to protect the carbon fiber. It is several inches from the electrical plug.

 

[AZ800]

Thx for the heads up!

 

[JLeosnow]

I took a look at my Pro's throttle cable and it is zip tied to the CF support tube with a rubber grommet to protect the carbon fiber. It is several inches from the electrical plug.

Same with mine.

-John

 

[akmclean]

Mine was zip tied as well but for whatever reason it rubs that harness too. Maybe just a fluke.

 

[wjl]

Looked at mine today very close but not rubbing. Just for extra measure I installed another length of split loom.