Matching factory elec. connectors?

[xc6rider]

Got a few electrical connectors id like to find, but not sure where to check/determine correct ones.

#1. Planning to build a plug in resistor jumper for the TSS.
#2. ECM power-up
#3. Fuel pump primer (this ones not real important). Primes easily anyhow...


Anyone by chance know what plugs these require/good place to order?

Thanks for any help!

 

[xc6rider]

This is the connector mentioned in another post for the TSS I believe, but need to verify if the TSS side is male or female I think.

http://www.corsa-technic.com/item.php?item_id=337&page=2

Can't find anything else on the others yet...

 

[Merlin]

Got a few electrical connectors id like to find, but not sure where to check/determine correct ones.

#1. Planning to build a plug in resistor jumper for the TSS.
#2. ECM power-up
#3. Fuel pump primer (this ones not real important). Primes easily anyhow...


Anyone by chance know what plugs these require/good place to order?

Thanks for any help!

I got the AMP Mate-N-Lok connector required for the ECU power-up connector from Digi-Key.

Check out this thread for an optional vendor(Terminal Supply?) - http://www.snowest.com/forum/showthread.php?t=326746

As an FYI, I was going to build a power up harness for the fuel pump as well but after testing with the ECU power up connector, I found that it only takes slight tug on the starter rope for the ECU to enable a momentary "priming sequence" for the fuel pump. This would come in handy when the fuel system has become bled down for whatever reason.