m7 speedwerx billit head and cylinders with new pistons

[1010kingcat]

i have a complete m7 700 top end it comes with a black billit speedwerx billit head and the cylinders look good came off running 05 m7 with 1200 miles comes with brand new pistons and rings im looking to get 650 for the complete top end

 

[green 440]

are the head for pump gas? and at what elevation?

 

[1010kingcat]

head is pump gas and for 0-3000 feet

 

[1010kingcat]

ttt

this is a good set up new pistons great up grade from a 600 head is in great shape cylinders look good no takers

 

[powder junky]

sent you a PM

 

[1010kingcat]

ttt

ready to pull top end off my sled billet head cylinders pistons its all going putting 800bmp on

 

[ezra]

ready to pull top end off my sled billet head cylinders pistons its all going putting 800bmp on

dont do it

 

[powder junky]

Dude, check your messages. I'm interested in the cylinders.

 

[snopro59]

Still have this? I would be very interested.

 

[ezra]

did you not read what he was putting in he will be needing to keep his stock stuff

 

[snopro59]

did you not read what he was putting in he will be needing to keep his stock stuff

WTF??? You retard.......I read that he is selling a M7 top end with a billet speedwerx head. What did you read?????

 

[ezra]

WTF??? You retard.......I read that he is selling a M7 top end with a billet speedwerx head. What did you read?????

no are you retarded may be a better ? go back and look at what I was commenting on.he said he was putting on a BMP 800kit in .so I replied you better keep your stock stuff you are going to need it who is retarded ? see that reflection in the mirror now go wipe the drool off you chin

 

[snopro59]

no are you retarded may be a better ? go back and look at what I was commenting on.he said he was putting on a BMP 800kit in .so I replied you better keep your stock stuff you are going to need it who is retarded ? see that reflection in the mirror now go wipe the drool off you chin

The post clearly states what he is selling. If he was keeping his stock stuff he wouldn't have created the posting. It was your jackass comments that is bashing Bikeman. Sounds like you couldn't get yours to run. You're probably as smart at tuning engines as you are posting on the internet, retard!

 

[ezra]

The post clearly states what he is selling. If he was keeping his stock stuff he wouldn't have created the posting. It was your jackass comments that is bashing Bikeman. Sounds like you couldn't get yours to run. You're probably as smart at tuning engines as you are posting on the internet, retard!

you are correct sir I could not tune my bmp 800kit and after putting the jugs on a flow bench I found out why.

 

[Catman 42]

BMP M8

OK I will bite. What did you find on the flow bench. I purchased a used BMP 800 Big bore and put it on a turbo. I was not impressed then it caught a ring on the exhaust port and took out the mag side. I had sent a pair of M7 cylinders to Millenium and had the bored out to 800 so I put them on. I didn't compare the BMP to the stock until after it ran awesome. I found the BMP cylinders where decked at the bottom 3.5 mm. That means I must have about .095 squish and it is a little soft off idle but very tolerable especially since it runs so well on top. Is this what you are referring to? The lowered ports?

 

[Catman 42]

Sorry wrong forum

Please reply to Arctic cat turbo