M Series A Arm Bolts

[TheOnlyBFC]

Looking to replace most of the A-Arm bolts in the sled this year. Does anyone know where to get these bolts (or similar) besides the dealer? I've checked Tacoma screw and mcmaster carr. Mcmaster had the proper length needed but they were a harder grade bolt which i would rather keep it the same as stock. Rather break a bolt than break an a arm. If anyone has any suggestions thanks in advance.

 

[AKGUY]

Not to hi-jack this thread, but on a similar note in regards to removing A-arm bolts, can anyone describe or provide a photo of cutting a small hole in the belly pan so you can get a wrench on the A-arm bolt to remove the bolt? Thanks

 

[kiliki]

Not to hi-jack this thread, but on a similar note in regards to removing A-arm bolts, can anyone describe or provide a photo of cutting a small hole in the belly pan so you can get a wrench on the A-arm bolt to remove the bolt? Thanks

remove the belly pan and use a hole saw just a bit larger to round out the factory opening to get the end of the wrench into.

just order the bolts from cat.
or you can get the light weight bushing kit and it comes with half of them.

 

[angle]

bolt place eg-Fastenal

 

[sledtahoe]

any auto parts store

Just go buy a grade 8 5in bolt I believe. they take few hits then bent and will break . I like to replace once they bent cause they fail and take out a-arm and sometimes shocks. Good prevenitive for 5 bucks a pair. dealer wanted 15 each no thanks!