im trying to put an m-10 in a stock edge chassis. i have the factory mount plates for the edge chassis but have trouble positioning the front mount plates. i have the rear ones in. if someone could give me some advice or measurements id appreciate it!
M-10 instal
- Thread starter doc_17r
- Start date
M-10
There should already be mounting plates with holes on the inside of the tunnel. use one of these holes. You'll have to finish drilling the the holes through the sides of the tunnel.
Also when putting the skid frame back in always position the front and start the bolts before you bolt up the rear of the suspension. It's pretty hard to get the front bolts in if you already have the rear bolts in. I know this from experience.I screwed up. Hope this helps.
There should already be mounting plates with holes on the inside of the tunnel. use one of these holes. You'll have to finish drilling the the holes through the sides of the tunnel.
Also when putting the skid frame back in always position the front and start the bolts before you bolt up the rear of the suspension. It's pretty hard to get the front bolts in if you already have the rear bolts in. I know this from experience.I screwed up. Hope this helps.
Similar threads
