HELP with SRX powervalves puller

[aksnomachinechic]

I need some advice on how to reconnect the cable from the power valves to the puller.

I need to know which slot and which groove each cable goes in? One came out and I want to make sure the other two are in their proper location.

 

[SRXSRULE]

The powervalve motor is marked. Look closely where the cables go in and there is a 1,2,3, stamped in the aluminum. Eric

 

[aksnomachinechic]

The powervalve motor is marked. Look closely where the cables go in and there is a 1,2,3, stamped in the aluminum. Eric

Thanks!!

Yeah, I see that..... but the cable itself isn't marked. Which bullet head (end of cable that attaches to the puller) of the cable goes into which slot in the puller? - it would seem logical that the top cable would be #1 and so on but the cable itself isn't marked so how do I know if I have the right cable in the right number?

 

[SRXSRULE]

Cylinder number one goes into slot one on the motor. Cylinder one is the clutch side of the engine. Just follow the cbales. Eric

Oh yeah, you better take out the valves and clean them. Thats what causes the cables to come out of the motor, Dirty valves hanging open.

 

[aksnomachinechic]

Yup, I cleaned em. Thanks again for all your help Eric!

 

[aksnomachinechic]

Eric, I Pm'd you for more help. Thanks!