Help on Pro skid mounting point measurments please :0)

[indyseven]

Just wondering if there is anyone that can help me with a couple of measurements on a 2012 rear suspension. I am going to mount my new 163" Pro skid and 5.1 track into my Mod GEN II chasis so I'm looking for a measurment from the center of the driveshaft to the center of the front mounting arm and the center of the front mounting hole to the center of the rear mounting hole.

Any help with this project will be greatly appreciated.

 

[indyseven]

TTT

 

[mountainhorse]

Same as the IQ... But uses metric bolts to mount it.

From a previous post

http://www.snowestonline.com/forum/showthread.php?t=78081

With a good Starrett tape.

1. Center of Drive Shaft to center of front mounting hole. 9 & 1/8”


2. Top of tunnel ( Inside tunnel) to center of first hole. 5 & 7/16”


3 Distance between centers of front and back mounting holes 31 & 7/8”


4 Top of tunnel to center of rear mountijng hole. 8 & 7/8”

.

 

[indyseven]

Thanks Mountainhorse that will help out sooooo much. You rock dude.