Helium hood fit and finish

[Eatstone]

Can I see some photos of your installed helium hood specifically by the factory intake on pull cord side.

The gap I have vs the gap on the clutch side is way off, 1/2”.

I’ve reached out to the seller so I’m not worried about a resolution.

 

[Wheel House Motorsports]

Can I see some photos of your installed helium hood specifically by the factory intake on pull cord side.

The gap I have vs the gap on the clutch side is way off, 1/2”.

I’ve reached out to the seller so I’m not worried about a resolution.

One thing I've seen is they are fairly pliable. Of they've been stored awkwardly they will not fit properly at first.

That being said fit and finish isn't amazing

 

[Eatstone]

One thing I've seen is they are fairly pliable. Of they've been stored awkwardly they will not fit properly at first.

That being said fit and finish isn't amazing

I’d say the overall fit is good, this looks like maybe an oops when they trimmed it.

 

[kylant]

mine was a little loose on the right side where the dzus fastener attaches. i redrilled the hole a bit further back and it made it much tighter