Error code 520194, 7... What's this mean?

[joshua335]

Anyone know what this means? Sled runs like the TPS is out of whack, but the dealership set it in the spring. I went to start it up this week and now it's giving me this. Can't stay running without some throttle and engine light starts blinking. My throttle play is good. Plugs good, except it looks like the left side plug seems a lot mor rich then the right side. Thoughts??

 

[joshua335]

From what I can find it's my throttle switch signal, says that my throttle is stuck. Hmm, looks like I have a bad throttle sensor?

Just looking for some confirmation from some knowledgable snowest peeps!

 

[cascadesnowjunky]

Code is throttle stuck, I bet your throttle cable has to much free play, tighten it up a bit. You can check by holding the little button in under the flipper and see if it idles i bet it does.

 

[joshua335]

I'm playing with it in the garage, seems to be no happy spot. Either too low and slowly dies. Or tighten it up and RPM jumps up and down real quick. Gonna keep givener here

 

[cascadesnowjunky]

I forgot the new ones dont have the little tittie sticking out that the flipper makes contact with, the newer ones are on the pivot part of the flipper. Make sure that is free to move a little so it makes the switch in the throttle block. you do not want to tighten the the cable to where the throttle bodies dont close all the way either, just take the slack out of it.