Where to plug in for an electric helmet visor on a 13 pro rmk, dealer said to go to gauge cluster, thought I could go to dc, or ac plug-in under Velcro strap, not sure which one.can anybody shed some light in the situation?i don't wanna cut wires on the sled if I don't have to.
Electric helmet visor
- Thread starter squezz5
- Start date
I have not done this in years. But. No need to cut wires. Get a wiring diagram for your sled and connect to the hot and chassis ground according to the wiring diagram with the following (type) inline connectors.
http://solutions.3m.com/wps/portal/...CPgs_2JW5T3H8C9_N2RL3FHWVK_GPD0K8BC31gv)&rt=d
http://solutions.3m.com/wps/portal/...CPgs_2JW5T3H8C9_N2RL3FHWVK_GPD0K8BC31gv)&rt=d
S
sledneck_03
Well-known member
If you have the Polaris RCA style pigtail it plugs right into the harness.
I found the rv style plug under the headlights which produces 12+ volts while running, which is required for the visor. I'm goin to install a switch that lights up around the 3 switches below steering post so I can see those, and be able to turn it off and on when needed, and maybe see the gas gauge as well. I would use the dc plug in the Velcro above the clutch but its impossible to find the mating connector for it to make the harness. The ac plug doesn't produce enough voltage.
