CMX BELT DRIVE - CMXDS

[CRAZY MOUNTAIN XTREME]

We have kits in stock and ready to ship for PRO RMK's
$2550.00 with Wahl Bros Drivers or + $100.00 for Avid Drivers. This system drops and rolls the trackshaft down an inch and back an inch from stock location. You can run a 3" track with 8 tooth drivers with about 1" of clearance. 7 tooth drivers are too small in diameter and cause a huge loss of efficiency. Added bonus...the CMXDS has 4 piston billet machined brake caliper that brakes on the trackshaft. Another bonus is you don't have to butcher your sled to put our kit on, so you can put your stock stuff back on and put the CMXDS on your new PRO next season. Call 406-686-4921 for more details and to order.

 

[Reg2view]

Real purdy and smart way to adapt to a stock chassis, and move to another.

 

[Kcjepperson]

I'm my opinion, well worth the money! I put some hard miles on my sled last year after stripping the cogs off the stock belt drive system. I never had a problem with the cmx belt drive system. And the added peace of mind with the drive shaft not tearing apart and also having the brake there also means you can stop if the belt ever did break. Awesome product and top notch customer service, Mark is a great guy to work with.

 

[Jay]

Very impressive product. Do you have the same setup available for an IQR chassie?

 

[CRAZY MOUNTAIN XTREME]

Very impressive product. Do you have the same setup available for an IQR chassie?

Sorry...we have not built a system specific to the IQR.

 

[philsummers21]

Do you know if this will work with a boondocker turbo?

 

[POLZIN]

this is on my list for bonus time !

 

[CRAZY MOUNTAIN XTREME]

Do you know if this will work with a boondocker turbo?

Only if you re-locate the muffler. Sorry.

 

[nottyn8]

That is a beautiful set-up! Very well done!

 

[moly may]

What is the weight difference between your set up and stock? Thanks you.

 

[richracer1]

Here we go again.

 

[moly may]

Just a question. Is it a secret?

 

[philsummers21]

Only if you re-locate the muffler. Sorry.

DAMNIT.....

 

[likkerpig]

Man that is beautiful!!

 

[AKtoad]

That's a bad mamajama right there.

 

[Jay]

Well it's only one unit but if you build that setup for the IQR chassie I will commit to one. Please.

 

[TheJett29]

What is the weight difference between your set up and stock? Thanks you.

2.5 pounds including the way stronger driveshaft and jackshaft.

 

[zr600]

Will it work on the 11-12 which wasn't belt drive from the factory?

 

[Leaf27]

Will it work on the 11-12 which wasn't belt drive from the factory?

Yes.

 

[CRAZY MOUNTAIN XTREME]

What is the weight difference between your set up and stock? Thanks you.

Sorry...I answered this already, but it did not show up.

Our system is about 2 lbs heavier than the stock belt drive system. However our system is noticeably more efficient than the stock system. We have replaced many stock systems with ours. In fact we have sold more CMXDS's for 2013 PRO's than the previous years.

When we grab the front bumper on the PRO (with stock qd) and pull it across the floor, the track skids...after we install our system you can pull the same PRO with the same track across the floor and the track will roll free. It is also seat of the pant noticeable.

Thanks for your question