Changing ramps

[shokaconbite]

I was changing my ramps from a 414 to a 415 and am wondering how the best way to get the pins that hold them in clutch, out of the ramp itself, without damaging anything.
thanks
kyler

 

[pinnedunderdoo#3]

well im guessing a light tap with a bit of wd 40 should get it out no problem, shouldn't be to hard to get out or wreck anything that i can see

 

[Macattack]

I used a bench vice, rubber mallet, and torch to heat the pins to get them in. It wasn't too bad of a process. Pinch the pin not the ramp. I guess you can do the same thing to get them out. Make sure you re-attach the pins to a 45 degree angle as shown in the maintanence manual. Otherwise they'll flop around in the clutch.