Just received my BMFab rear bumper. No instructions were included and clearly some things need to be drilled out. Now my question is there are two rivets on the lip than need to be drilled out for the bumper to fit flush. Next the two forward rivets on the top side, are those holes suppose to line up with existing rivets, drilled out, and the replaced... Or am I drilling new holes and then riveting?
Seems like things "should" line up, but they do not.
Also for a note, hardware comes un coated, which I find fairly disappointing when ordering a black powder coated bumper...
Seems like things "should" line up, but they do not.
Also for a note, hardware comes un coated, which I find fairly disappointing when ordering a black powder coated bumper...
