axys turbo problems

[colbypetersen]

#1 my sled is showing a code biometric barometer pressure
witch I'm thinking is just that my intake are plugging up so what is every one doing for more intake air.
#2 my track is skipping i just ordered some drivers and any stab kit from avid products any what have others done?
#3 my sidekick base kit i burned my pull cord in half why?
#4 where can i get the add on clips for the unclipped widows on the 3" polaris track

 

[sumtinwong]

#1- remove foam behind frogskin cover and add a slp air intake kit.
#2-did the same {avid and anti stab 4 wheel kit} no slipping hear!
#3-i run a sliber kit and haven't burnt any thing {I put a full slp vent kit on the panels clutch and EX. side} not a bad idea HP=heat peal all the foam off the panels heat tape where needed and vent that hot SOB!
#4-E bay.....or amazon if you are one of those guys : you can get the clip tool their also. don't remember witch clips but their was a write-up mmmm last year maybe, about that and it told you what clips and tool {they should add that to the sticky under lords adhesive} hope that helps good luck colbypetersen