Anyone interested in a non power valve 800 with a Carl's Cycle 860 kit on it??

[800 Escape]

I have a Struther's 860 that is Non VES cylinders and runs on pump gas. It has low miles and I would let it go for $1600 plus shipping with everything needed to run. The motor had the big bearing done to it when the big bore kit was installed, and has the big water pump belt and tensioner from PSI for better assurance to a long life. It's currently in an Edge chassis but would fit in a GenII also. It will include complete motor, carbs, clutch, electrical, engine base plate, and it has VForce 3 reeds. Also have an SLP Single for an edge chassis to go with it for another $150 plus shipping.

 

[Gmiller]

Is this a complete engine with everything included to run??

 

[800 Escape]

yes except for pipe, I have an SLP single for another $150 with it if needed.

 

[Gmiller]

Sorry for so many questions, Big Bore Bearing on clutch or no? And the year?

 

[800 Escape]

Ready to Rip!!! Very Very Torquey Motor!!!

 

[800 Escape]

TTT for a very good and ready to run motor!!!

 

[800 Escape]

I will let it go for $1500 plus shipping!!!

 

[nrewerts]

Very interested, sent you a pm.