850 RPMS

[madmax]

Also In utah running 8000-10,000 feet. Had just over 200 stock miles and ran very good with the 66g weights at this altitude. The venom blk/red secondary spring with Teflon washers is an added bonus, but not absolutely needed if you don’t know how to pull the secondary apart.

 

[Rdeleers131]

Also In utah running 8000-10,000 feet. Had just over 200 stock miles and ran very good with the 66g weights at this altitude. The venom blk/red secondary spring with Teflon washers is an added bonus, but not absolutely needed if you don’t know how to pull the secondary apart.

I do, I just dont have the press tool.. although I should get one. I would like to add the washers as well.

 

[Sheetmetalfab]

I do, I just dont have the press tool.. although I should get one. I would like to add the washers as well.

A 16” piece of 1/2” allthread through a board works great.

A 6” piece of unistrut with 2 bolts and nuts through each side to push on the spring retainer.

 

[Rdeleers131]

A 16” piece of 1/2” allthread through a board works great.

A 6” piece of unistrut with 2 bolts and nuts through each side to push on the spring retainer.

solid idea, I probably have all that stuff in my shop.

 

[Sheetmetalfab]

solid idea, I probably have all that stuff in my shop.

I’ve also used a drill press and a slotted piece of wood the same way.

Make sure the pieces don’t get away from you. (Yep i bounced parts off the walls)

 

[Rdeleers131]

I’ve also used a drill press and a slotted piece of wood the same way.

Make sure the pieces don’t get away from you. (Yep i bounced parts off the walls)

Makes sense lol