2021 AXYS 850 162 POWER CLAW BELT DRIVE MTNTK TURBO

[Teth-Air]

Did you have to cut the front of the rails to install the anti-stab or just remove the caps?

 

[chrisco]

So on to this now, just trying out tracks. Stock doo track cut down to 15 wide 3.5 pitch.

 

[chrisco]

Did you have to cut the front of the rails to install the anti-stab or just remove the caps?

You always have to cut the rails Chris.

 

[Teth-Air]

You always have to cut the rails Chris.

I now you did but hoped the Khaos bend would have changed this an given more clearance.

 

[chrisco]

Well I gotta say this skidoo track hooks hard !!!! This sled pulls like a train. I have never had a track that loaded the motor like this one does, i lost about 300 rpm.

 

[damx]

Iv been telling everyone how good they work. 3 more people I ride with will have them on axys 850 very soon. I'm out climbing axys 800 turbos at 5 psi, because they have the stock track, its crazy.

 

[madmax]

How are you guys cutting the extra 1/2' off each side of the doo track?

 

[Sheetmetalfab]

Iv been telling everyone how good they work. 3 more people I ride with will have them on axys 850 very soon. I'm out climbing axys 800 turbos at 5 psi, because they have the stock track, its crazy.

Stock 174 polaris 3” track?

 

[damx]

No, 4 of them have 163 2.6" and one 174 3" , but he runs 7 psi.

 

[chrisco]

How are you guys cutting the extra 1/2' off each side of the doo track?

Table saw.

 

[chrisco]

No, 4 of them have 163 2.6" and one 174 3" , but he runs 7 psi.

I dont doubt that at all that track hooks hard. I would love to try one on a NA sled and spank skidoo turbs all day lol.

 

[damx]

Its only 3/8" each side. I just used a olfa knife and straight edge.

 

[chrisco]

Not much to look at but a small vid steep with not much run into it.

 

[Beauford t]

Not much to look at but a small vid steep with not much run into it.

what drivers do you run with the doo track?