2012 Pro 800, Fuel Resistor code 524007-3, any ideas?

[mtnoak31]

My 800 pro is throwing the 524007-3, Fuel Resistor voltage to high.
Is this just a bad fuel resistor plug? other issues?
Sled starts and runs fine. 2400miles, rk tek top end at 1500miles.

Thanks!

 

[mtnoak31]

I replaced the fuel resister. Its still throwing the engine code. Any ideas?

 

[Quicksand]

Try following the wires back as far as you can and see if there's anything that would cause high resistance in the wiring, if you have a schematic available for it, unplug the ecm connector and check resistance end to end of both wires with a multimeter, I assume the wires that come from the resistor both go back to the ECM and the ECM monitors the resistance on the loop. If both wires have less than 1 Ohm I'd say they're good