Bought a 2012 arctic cat m800 with stage 2 cutlers turbo last year, haven’t looked into it yet as I’m new to aftermarket turbo sleds, it will idle just fine but when you get into the throttle then let off it’ll fall on its face and die, but then you can start it right back up, has a code on the display as it’s idling for the temp sensor not sure if that has anything to do with it, this is the first sled I’ve owned a turbo so I’m open to any ideas what could be causing it.
2012 arctic cat m800 with cutlers stage 2 turbo kit will idle but dies when you let off after being on the throttle
- Thread starter Ruger172
- Start date
Check to make sure the intake air temp sensor for the factory computer isn't mounted into airbox. Depending on what control box (Cutler usually used Attitude Industries) it may have its own intake temp sensor and/or the factory one should just mounted in open air. Turbo charge air temps are too high for factory sensor and mounted in air box without a resistor setup will cause a lean condition.
I will check that, yeah it has the attitude industries fuel controller on it.
