Install the app
How to install the app on iOS

Follow along with the video below to see how to install our site as a web app on your home screen.

Note: This feature may not be available in some browsers.

  • Don't miss out on all the fun! Register on our forums to post and have added features! Membership levels include a FREE membership tier.

2006 stock apex bog

I have a stock 2006 apex that I just bought. It has a slight bog when it is floored off the line, is this normal or can it be repaired? Thanks.
 
not normal. I know you said stock, but has ANYTHING been done to the exhaust or airbox/air filter? Does it do it ALL the time or just in certain conditions.

You can make some adjustments with the OEM gauge that will fine tune your fuel trim to fix issues like this. Eric
 
thanks Eric

Thanks for your reply Eric, I believe it is bone stock, all appears original, I cannot really say if it does it in all conditions as we have almost no snow, I just took it up and down my road a few times, it is nothing serious but if I can get rid of it without affecting dependability, it would be nice.
 
Well at this point I would wait untill you have snow and run a tank or two of good fuel through it and see how it responds when its fully warmed up in normal riding conditions. Eric
 
My wife's 06 attack did the same thing. I tried the CO adjustment and it never worked. It would even bog if I just burped the throttle quickly even while the sled was sitting still. I removed the fuel injectors and cleaned them out with throttle body/injector cleaner. You have to unplug and remove each injector. Use some alligator clip leads and a 9volt battery to power them up so that they open up. Spray them with the cleaner and blow them out with compressed air. It's a relativly easy job that only takes about a half hour. Fixed my problem. Good luck.
 
Last edited:
The Ape is notorious for a plugged fuel tank vent.

Next time this issue arises, stop, and quickly remove the fuel cap. If there is pressure in the tank, you found your problem...
 
I would point to injectors. Number 4 is known to collect some debris.
Test them and clean them and should be good to go.
 
I'm glad Snowaste is getting back to a level of helpfulness...

There... you have several bits of advice from experienced guys that know and care - at no charge!

Thanks Neil!
 
Premium Features



Back
Top