2.4 track on rmk edge

[ecut]

Do you have to modify the drivers to fit a 2.4 polaris track under an RMK edge chassis, or will it bolt right in?

 

[05rmksteve]

You need to go to a smaller drivers or do a drop and roll chain case. I have a set of avid drivers for a 2.86 pitch track anti ratchet. They have about 200 miles on them.

 

[whoisthatguy]

You will get a significant increase in traction with a camoplast challenger x 2" lug, over the series 3 or 4 polaris track. No need to go to a 2.4 because it is too much trouble.

 

[Jay]

Yes it will fit. Yes it is a b!tch to get in. Hands down better than any 2"

 

[sno*jet]

taller the better! even if its just 2.125" series 4.
id change the drivers and go big

 

[konarider]

I got the rmk vertical edge I assume it's the same, would a 2 1/4 fit with out changing anything?

 

[Lexar]

You will get a significant increase in traction with a camoplast challenger x 2" lug, over the series 3 or 4 polaris track. No need to go to a 2.4 because it is too much trouble.

Then again the camoplast Challenger 2" lug track is 710$ and the series 4 polaris track is 299$

that is for the 159" length, have the serie 4 track on my Vertical escape, and go wherever i want to go

 

[konarider]

Will the 2.25 fit with stock drives?

 

[klim man]

will 8 tooth anti ratchet no slip drivers be enough clearance for a 2.4 challenger track?