I recently picked up a 151 skid to swap into my 98 xc 700 just wondering if anybody has the tunnel measurements for the skid mounting.. Does the 151 & 159 have the same mounting location..
151 edge rmk skid install measurements
- Thread starter best47
- Start date
O
old fat guy
New member
i have a 03 151 tunnel laying around , where do you want the measurments from ?
Is it got the track driver in it yet or is it a bare tunnel
The 151 and 159 used the same mounting points. I can measure mine up today or tomorrow and get back to you.
O
old fat guy
New member
drivers are out , sleds all boned out.
O
old fat guy
New member
from center of drive shaft 9in back , 4 7/8 down from inside top of tunnel that was 3 7/8 from bottom of running board and about 2 above the drive shaft . rear hole is 30 7/8 back from front hole and 1 below running board . there was several rear holes but that was the only one that had been used , the other holes were horisontal not up and down . hope that helps
Thats what I needed thanks alot for taking the time to measure that for me!!!