13 800 Pro RMK handle bar risers

[ChadRMK]

Does anybody know if they make a handle bar riser for the 13s? I was told the risers for the 10s-12s won't fit. I was looking for a 2" riser, can anybody steer me in the right direction? Thanks!

 

[mickyd32]

Here is the deal. The riser to fit the pro tapers is a narrower bolt pattern. I believe about 1/2 to 3/4 of an inch. There are a few that fit this. I've used a Powermadd and another that I can't remember the name of. If you are at your dealer just compare the riser block to a "stock" style polaris one, if its narrower it's the one you want

 

[mickyd32]

Also my cousin and I were looking at his 06 on the weekend and discovered the fusions and Rmks from 06 ran the narrow bolt pattern as well. So one off those sleds would also fit

 

[diesel5]

I Put these on my 2011 and 2013 they work great 1.5" is what i did ads just enough. http://www.aftermarketproducts.com/catalog.php?mach_type=S#AMP-9914 part numbers AMP 2007-2010 all fit the new pro

 

[BigK]

RSI makes a set for the new Pro's. I've got a 3" on my 13 Pro, my buddy did the 2". Both work great.

 

[himarker]

Im also running the RSI angled 3" riser. Works awesome. Had to enlarge the holes in the post slightly for the bigger bolts, but other than that no issues whatsoever.

 

[supersmith]

I have a powermadd 2" on mine. Only complaint is that I had to buy longer bolts and nuts to make it work.

 

[hink320]

I'm running the AMP riser as well and it's a thing of beauty!

 

[mrquick68]

This is the first sled that i've not had to add a riser. At 5'11" its perfect for bone stock. Bars are tad too wide though.

 

[mountainhorse]

DIFF RISERS I KNOW ABOUT

RSI Racing 15°
http://www.rsiracing.net/catalog/pr...id=24&osCsid=9f3a9f2869a99a8d9b68242cce3c4718

Ole's 15° billet angled. Note: the Ole's risers shown below are the 30°
http://www.olesmachine.com/polaris.htm

AMP (Aftermarket Products) 12°
http://www.aftermarketproducts.com/catalog.php?mach_type=S

PowerMadd 0°
http://www.powermadd.com/products/nonpivotriserblocks.html

.




.

 

[likkerpig]

Powermadd has never let me down. Rsi, two different trips 2 different years. I will personally never use an Rsi riser again. I know plenty of people who have been fine, just not me.

 

[Pro-8250]

I have a powermadd 2" on mine. Only complaint is that I had to buy longer bolts and nuts to make it work.

Same here.