I've already watched every Youtube video I can find. So a little back story - I put the 34" Zbroz A-Arm kit on my '23 Shredder last year. The spindles came out of the stock a-arms just like the videos showed, banging on it with a dead-blow hammer for a few twacks popped them right off. So I then installed the Zbroz 34" a-arm kit only to find out that my turning radius was reduced with the stock spindles.
Fast forward to this year, it dawned on me Zbroz made a specific set of spindles that you had to install to regain your turning radius for use with their A-Arm kit ..... Which was super frustrating to me because they made no note of that whatsoever on their website.
So anyways, I get the Zbroz spindles in and I go to install them and I cannot for the life of me figure out how to pop the lower mount out right now. I've banged on it as hard as I dare with the dead blow, I've doused it with penetrating oil and let that soak in hoping that would loosen it up, and I just went and rented a tie rod fork kit from Autozone and I can't even get it to pop off with the tie rod tool.
So my question is - What the flying f*ck am I supposed to do in order to get these spindles off? Is there some Skidoo specific puller tool somebody makes? THis is absolutley maddening to me ..... it just shouldn't be this darned hard to replace a front end on a snowmobile.
Fast forward to this year, it dawned on me Zbroz made a specific set of spindles that you had to install to regain your turning radius for use with their A-Arm kit ..... Which was super frustrating to me because they made no note of that whatsoever on their website.
So anyways, I get the Zbroz spindles in and I go to install them and I cannot for the life of me figure out how to pop the lower mount out right now. I've banged on it as hard as I dare with the dead blow, I've doused it with penetrating oil and let that soak in hoping that would loosen it up, and I just went and rented a tie rod fork kit from Autozone and I can't even get it to pop off with the tie rod tool.
So my question is - What the flying f*ck am I supposed to do in order to get these spindles off? Is there some Skidoo specific puller tool somebody makes? THis is absolutley maddening to me ..... it just shouldn't be this darned hard to replace a front end on a snowmobile.