i just finished a rebuild on a 94 zr700 and i have a pretty bad bog when the clutch engages..
i am at 5000ft (parking lot) and ride 5000-8000ft..
i have 340 mains in it now for the parking lot testing..
needle is on middle clip, a/f screw is 1 turn out
the bog is so severe that the sled either will slip the belt, or bog so bad it wont even move..
carbs are good, so i am thinking the clutch needs a rebuild..i never touched it last year when we got it and i know the guy we got it from didnt touch it the prior year..
would primary/secondary springs being sagged from age cause this..
the weights do move slightly which i would think needs new bushings..
i do not have a clutching chart or jetting chart for it..any help would be extrememly greatful..
thanks in advance guys!
i am at 5000ft (parking lot) and ride 5000-8000ft..
i have 340 mains in it now for the parking lot testing..
needle is on middle clip, a/f screw is 1 turn out
the bog is so severe that the sled either will slip the belt, or bog so bad it wont even move..
carbs are good, so i am thinking the clutch needs a rebuild..i never touched it last year when we got it and i know the guy we got it from didnt touch it the prior year..
would primary/secondary springs being sagged from age cause this..
the weights do move slightly which i would think needs new bushings..
i do not have a clutching chart or jetting chart for it..any help would be extrememly greatful..
thanks in advance guys!