B
Ok so last run of last year I was running low on oil. So my buddy had some Polaris full synthetic. I dumped that in and mixed it with APV Arctic cat oil that was left in the oil bottle. A mile or two down the road it started boggin down and wouldn't clean out or rev over 5500 RPM's. So limped it back home. I didn't think much of it. Just some plugs and empty the oil bottle out and put new plugs in. Well I changed the oil last night and rode this morning with new plugs. Still wouldn't clean out. Changed plugs again and still won't clean out. I pulled out the power valves and cleaned them up with some wd40 and a razor blade with some scotch pad and put them back in while out on the trail today. Still same issue. It almost sounds like it's missing and not firing right. When I pulled the pipe off I noticed that the clutch side piston was full of oil. The oil was very grippy. It was greasy with metal to metal but got some on my finger and I felt like spider man. I could grip to anything. The question is... what did I do? I read some things online where people would run Polaris ves oil and they were fine... and what do I need to do. Spent a couple hours on the trail today trying to clean it out. It idles great. No problems. It will run and hold 5300 RPM's but not that well. Once I mash the throttle it doesn't feel like there is spark on one side. Need help