07 m1000

[mluker]

i was wonder if anybody had an idea ,sled wont rev over 6000 rpms,ran good for 2 days in valemount 3rd day fine half way up to keyhole and would bog as soon as the rpms came up ?

 

[Samurai]

i was wonder if anybody had an idea ,sled wont rev over 6000 rpms,ran good for 2 days in valemount 3rd day fine half way up to keyhole and would bog as soon as the rpms came up ?

Dont know your situation. But had a M1000 do the same thing. Was eventually discovered it was the main harness. Sled was going into limp mode. Didn't flash up on the instrument gauge. Would just bog and cut at 5800 to 6000 rpm.

Good Luck

 

[mgdjeepster]

almost gaurntee it is one of your power valve cables, check the servo motor, one of the cables probably frayed and busted right there, just pull that little cover off and you'll see it

 

[mgdjeepster]

in case you don't know the servo motor is directly above the clutches, has a clear white plastic cover over it that is kinda a pain to pull off........ good luck