I just picked up my 600 rr last night and I'm wondering if anyone makes a better boards, FU boards setup etc. for this sled. I have looked around but have not seen anything available for the RR. Its horrible. had 3' of fresh powder last night (flatlander) and the snow build up was awful.
Running board question (600rr)
- Thread starter 13below0
- Start date
I´ve been searching for the same thing but haven´t found anything good. I would say it´s best to mod it yourself!
i am cutting some out on the plasma table monday. they replace the stock brace and follow the same lines with open rectangles on the bottom (better boardish). i'll post pics when i get them done then pm if ur interested.
carl
carl
Please post up asap. I have access to a cnc plasma at work but I dont think I have any good way of adding any teeth for traction. I will definitely not be able to do it on the sheet metal brake we have its way to big. Thoguth about trying to make a small fixture and to it in a vice, but didnt think it was worth it until I actually rode the thing. haha
fu boards should be done this week for that sled
keep checking xxxmodrods.com
keep checking xxxmodrods.com
S
shortstop20
Well-known member
^^^^^^^^^^^^
What about for a Pro-X?
What about for a Pro-X?
got them cut out; getting bent and hopefully powder coated tomorrow. i'll post pics of them installed by friday (hopefully)
Looks good. I think you need to make a set for the bravo too. It will be the back up sled.
That looks like it will be a big improvement over the stock setup.
just back from the powder coater; he turned it around in 3 hours for me 
going on tonight...
going on tonight...
Looks good. 1 question why didnt you put the holes in for the rivits with the plasma or at least drill them before you had them coated? Very nice looking piece. PM me a price if your gonna make a few sets. I'm sure it will be cheper than me going out and buying a new brake so I can make 1 set for myself. haha. If your going to do a bunch more maybe we can work something out as we also do powdercoating in house.
Rox sell aluminum plating for IQ race running board
I hadn't planned on selling these but since everybody seems to like them so much
...For a price I was thinking $150.
They will be pre-drilled.
Here is a pic installed.
how do you think they will hold up to the loads of jumping?? I can see myself bending or breaking them without all the support that was cut away.
i made the tabs on the side of the tunnel about .5" taller than stock for extra support. the holes cut out are in line with the lower sections on the side of the tunnel. also the bent up traction "bar" ads a lot of rigidity.
Like jet fuel said they feel every bit as stiff jumping up and down on them in the shop.
I am pretty sure the pro x running boards are very very close the the same size as the IQR. I would take a set, is it $150 powdercoated black?
I would also take a set
S
shortstop20
Well-known member
If they will fit Pro-X boards I would be interested in a set too.
How much of a PITA is it to drill out those flat rivets on the stock fishbones?
Similar threads
