ZBroz Springs
- Thread starter ditch1000
- Start date
S
sledaddiction
Well-known member
How was the install? I haven't messed with suspension setups too much, but I have been considering doing the same thing.
R
R_8_N
Well-known member
From what I've gathered the rear springs are a little soft. But the 11 and 12 have a higher ride height in the front than the 13. They lowered the front a little making the rails sit flatter making the rear work as it should.
I have a 12 and the front seemed fine but the rear would always hit the bump stops. I'm about 260. Front felt fine but Im putting exits on the front and adjusting the ride height to get the rails flat with the exit springs on the stock rear shocks.
Why not call zbros and get there recommended install position?
Last edited:
The install was super easy. I had the the suspension apart for powder coating so I just installed the spring kit after. All you have to do is loosen off the stock springs, slide the keeper out and unbolt the shock from the suspension on 1 end and the springs slide right out. Just slide the new springs in, put the keeper back in and bolt the shock back on.
I found the stock springs too soft and my sled bottomed out lots on the trails to the riding areas here in BC. This kit should help lots; I'll probably call Zbroz tomorrow and get a starting point from them.
What springs did you order from them, looked at their website and there are many springs to chose from???
There is a kit there for the Pro RMK with walker Evans shocks. Pro rmk/assault dual rate spring kit. Also Pro rmk/ assault rear spring kit. There are no part # on their site.
Iput the polaris OEM fat boy spring in the rear shock and seems to work good. I am 240 with gear
