thanks for all the help with changing the track all....
yamaha viper track change.
- Thread starter hans2003
- Start date
Did you get it done? If it was your first time, next time will go alot better.
Good luck
Good luck
yea i got it done, when pulling the drive shaft i didnt have to pull any wheels off, instead i pulled the entire chain case breaks and roter, seemed alot easy since i dont have any kind of a press, thanks for the tips though....
Sounds like you were trying to do everything backwards. Normally you disassemble chaincase after removing skid (rear suspension), remove chaincase and left side driveshaft bearing, and slip out driveshaft with track. Alot of people forget the Torx or Hex screw on the inboard (tunnel) side of the left side driveshaft bearing.
just changed the track on my viper last month first time was a slow go but definatly learned a few things rode her the other day and the track didnt fly off so everything is good .
nice nice i am hoping the same happens with me, cabin got 14 inches today....
wish i was there hit a stump the other day f----- the steering arm and the tie rod on the viper . if there was 14" wouldn't have happened good luck 
