Yamaha footpeg relocate.

[powdermuncher]

Here is a plate I made to relocate the foot-pegs on YZ and Wr's. It is 1.5 inches back of stock or the second hole is 2' back of stock. The 2" setting only works for E-start bikes as it reduces the swing of the Kickstarter to much. I made these 1/2 inch wide , but also made a set 1" wide that I prefer.
There is also a mod done on the stock peg that removes the bottom Pipe section of the foot-peg and drops it By 1/2 inch as well as 1/2 inch further back(Put the cut of section on the top right spring will go on the right foot-peg and the left on the right.One also needs to weld a new stop in the foot-peg mount for the new position) This setup together with a 2" handlebar riser move the rider weight far enough back for stand up riding whoops just like a wheeled bike.

 

[powdermuncher]

Guess a pic would be good

 

[powdermuncher]

Just build a new set for a friend -- instead of modifying the foot-peg and mount I used a larger plate and moved 2" back and 1/2 inch lower than stock with no mods on the peg or mount. Nice clean and simple
The peg position is the same as mine but 1/3 of the work to complete. I use my bike in summer for track days and at 6'2" like the mod to the pegs 1/2 inch lower and 1/2 inch back on the stock mount without the plated is nicer and more balanced than risers. I will try to snap a pic when I see his bike again.