wrench flashes on digital display in reverse on m1000

[UPsledder08]

every time i put my 08 m1000 sno pro into reverse the wrench flashes on the screen and it also says CCO where the elevation is suppose to be please help. it hasnt effected anything yet but i dont want it to in the future. any help would be helpful

 

[bcguy]

mine has done the same ,blew a belt and it breaks the reverse activation switch under your left footwell ,repair it and your wrench code will repair itself until the next belt blows and it does it again,later

 

[Fitzy]

I've had the wrench flash on my 08 m10 SP and ended up being the bolt holding the secondary clutch on was loose. Tightened and it went away. Hope this helps.