Would you check my Innovate AFR gauge?

[realbass]

Does it working correct?
Thanks

 

[AkLogan]

If your talking about it being extremely lean? It's been said somewhere else that the etec(assuming that's what that is) runs super lean especially at idle and just off. Could be giving you the really weird numbers.

 

[snow4shover]

Yes...your AFR gauge is working fine. The innovate has about a 15-30 Heater cycle which is the "Her"...you probably understood that. Other than that the AFR will be really lean 17-22:1 until you get into the mid range. These sled run very lean cause of the Direct Inject efficiency and it is nothing to worry about.

Go throw a leg over and see how it runs.

 

[realbass]

AFR Readings

One more question.
What is safe numbers AFR at WOT can you recommend for me at low altitude?
I have a lot hours with Cat turbo and Po and 11.8 readings is good for me, but i newbie in turbo etec.
Thanks

 

[snow4shover]

Same as your other turbos sleds. The Etec will eat up whatever fuel you throw at it. I would suggest 12.5-13.0.

 

[realbass]

Same as your other turbos sleds. The Etec will eat up whatever fuel you throw at it. I would suggest 12.5-13.0.

Thanks. But parts in my country is very expensive and USA suppliers very far from me.
I will try 11.8-12.

 

[turbo800]

Thanks. But parts in my country is very expensive and USA suppliers very far from me.
I will try 11.8-12.

That will work. I prefer 12.0-12.5 myself...