So I did a bar swap to the newer PC style bar on my M7 and in the conversion, I didn't re-install the headlight Hi/Lo switch, or any of the heat grips. My question is, what do I need to do to get the head lights to come on when the sled comes on?
Also, do I need to wire in a resistor to each hand warmer output? I know the M7's were sensitive to voltage, and I want to make sure I get this right.
Also, do I need to wire in a resistor to each hand warmer output? I know the M7's were sensitive to voltage, and I want to make sure I get this right.
