Where does the long pin go on Torsional setup?

[BlueByYou2000]

I just replaced all my rollers and forgot to keep an eye on where the longest pin/dowel goes? The pin sits towards the shaft then there is a billet hub that locks down onto it. I think it goes into any of the rollers on the load side, not the reverse side rollers. Is this correct?

 

[M1000Mod162]

yes I beleive that is right. I dont think it matters which ones as long as its the left roller on the top when your looking at it

 

[BlueByYou2000]

Looking at it from top, the left side roller is the reverse roller, not the load. I have the long pin on the right roller which would be load side. Is this right?

 

[BlueByYou2000]

Should also add this is a BMP torsional setup.

 

[M1000Mod162]

thats the same kit I have do you like at it at all? I have hated myn from day one the screws holding the cap on always break or back out. What setup are you running spring color and helix angle

 

[BlueByYou2000]

thats the same kit I have do you like at it at all? I have hated myn from day one the screws holding the cap on always break or back out. What setup are you running spring color and helix angle

Well the jury is still out on that. The 3 bolts on the cap need to be replaced with hardened bolts, then run some blue locktite. This is on a Crossfire 1000 R so my application is most likely different than yours but I am running the Sno Pro Green with a 42/38 helix. I have had a bear of a time with the 9 bolts on the back however. I recently replaced them with new hardened bolts and used red locktite. The stock bolts backed out twice, snapped and ruined a helix.

Im still trying to figure out if I installed the long pin right. Do you remember?