what spider can be used in a Polaris Primary clutch?

[yz400ex]

I have a clutch from an 08 Polaris 700 CFI. The previous owner didnt maintain it and one of the rollers worn out causing the roller pin hole to oval out and make the entire spider un-usable. I dont see that a replacement spider can be purchased, but I have 3-4 other spiders here from older year clutches. They screw on fine and fit inside the moveable sheave fine, but they are slightly different looking. Can one of these spiders I have from an older non cfi clutch be used in the the newer cfi clutch? Can anyone help me out with this?

 

[slash]

YEP STICK ONE IN AND HAVE IT BALANCED

 

[yz400ex]

So the older spider will work fine then? Other than a slightly different look, what is the difference?

Sent from my SPH-D710 using Tapatalk

 

[turbolover]

As long as the installed height and compressed height are the same and nothing binds on it through the full range of travel it should work.
Make sure that it doesn't hit on the cover and will completely slide down to the inner sheave. You will also need a guage to adjust the shim pack under your spider and adjust the correct installed height

This is as long as the inner bushing is not worn out and you have it completely balanced after putting it back together.