bought a track that was told was a 2.52 pitch turns out it was a 3 inch pitch. What size drivers can I fit in a 03 edge. I plan on going with slp anti ratchet drivers and need to know what tooth drivers to run on a 162x15x2 inch track.
what size drivers can I fit?
- Thread starter yamarider48
- Start date
8 tooth should be fine i used a 7tooth on my 03 edge to clear a 2.5 CE 162
(hmm... i did have a D/R i now remember )
hopefully others will chime in
you could call SLP i'm sure they would know # 208-529-0244
let it snow
(hmm... i did have a D/R i now remember )
hopefully others will chime in
you could call SLP i'm sure they would know # 208-529-0244
let it snow
Last edited:
Hopefully I have some input that will help. I just recently put a 163x15x2.4 5.1 series Polaris track under my 02 edge that was a stock 156 snocheck. I did some research and found that in order to run the anti ratchet (recommended for the track) I had to cut my slide rail tips and install anti-stab kit. I did have the 2.4 lugs and in order to clear I had to go to 7 tooth from wahl bros verses a d&r. Being you are only 2 inch lugs you should be able to go with 8 or even 9 tooth anti ratchet but you will have to cut your slide rail tips. Keep in mind this does change your gearing also if you go to a smaller driver. I was up on the mountain and had no problem whatsoever with track speed. But to answer your question, I think you should be able to get away with 8 or 9 tooth anti ratchet. 1 1/16 to 1 1/8 shaft size. Hope it all goes well.
