V-Force Reed Problems

[Sled101]

i have a 2006 RMK 700. This year I installed the v-force reeds. First time out the check engine light began to flash, and the sled seemed to be running lean. I have an aftermarket can, and intake. 2000ft is elevation. What are some of my options? Could i possibly reflash it, bump up the fuel, or is it possible to change the throttle position switch? Any imputs will help. thanks
-Sled101-

 

[sled_guy]

I don't think your problem is the reeds. I would go back over everything and make sure something isn't out of place. Check your throttle body boots for cracks, it was/is a known issue. Did you put the can and intake on at the same time or were they on there before.

Easy check on the reeds is to put the stock ones back in and see if the issue goes away.

sled_guy

 

[Sled101]

Yeah I replaced the boots when I put the new reeds in. The can was on it when I bought it, and I put the intake on 2 years ago.

 

[rdnorman]

when you moved your throtle boddies out of the way you probably either nocked the tps off a bit or more likely broke one of the wires for the tps they break really easly and they break inside the insulation so it is hard to notice.
http://www.snowestonline.com/forum/showthread.php?t=113278
part# for replacment harness 2203165 they are about 30 bux

Video for setting tps
http://www.snowestonline.com/forum/showthread.php?t=72725

thread on how to build a tps tester
http://snowestonline.com/forum/showthread.php?t=67427&highlight=900+tps+setting