Turbo Pro - Boondocker, skinz, timbersled*****NO LONGER FOR SALE*****

[philsummers21]

Listing my sled for sale. Its a 2011 Polaris PRO 163 with alot of goodies. 2500 miles, RKTek Pistons put in at 2000 miles. Asking 13500 as it sits and if you respond fast enough there is still some snow to go test it out, may suck but its snow. sled is dialed and absolutely rips. Pull and go. Will pull accessories to lower cost. And will entertain trades for stock Pro or Assault + cash. PM or email is philsummers21@gmail.com
+ 163 Peak 2.5
+ Avid drivers
+ Chain case mod to clear smaller drivers and 2.5" track
+ Antistab kit
+ Timbersled Mtn Tamer w/ IceAge Bomber Rails and Fox Evol and Float 2
+ Timbersled Drop Bracket mount (beefier then stock)
+ Skinz front and rear bumpers
+ Skinz Air Frames
+ NXT Lvl windshield bag
+ 3" riser
+ AEM air/fuel
+ Boondockers race kit w/ intercooler and EBC
+ Mtn Addiction Gas cans
+ Sled Solutions underseat bag
+ Zbroz front suspension w/ Fox EVOL Rs
+ Custom Wrap from Arctic FX
+ 2 cool vents
+ Rox Flex Tek 2 Handguards
+ Gauge Lift and vent
+ Polaris Skid Plate
+ Brand new set of reeds
+ RK tek Pistons installed @ 2000 miles, Everything else checked out good.
+ Boost-IT Motor Mounts

Sled needs nothing. It is setup to run around 11.5# at 8000' I run straight AVgas just for the simplicity of not having to mix but will run on 30% 110 and 91. Never once had to touch the box all season or turn a wrench on it except for a few stock a arms. (Zbroz fixed that) There is a small scuff, dent on 1 front shock but has not affected anything. tunnel, bulkhead, plastics, bumpers are all straight. Definitly a head turner. Any questions just ask. Im sure i have forgot a few things but you get the idea.

 

[philsummers21]

Also polaris installed a new motor at 1800 miles so this new motor only has 700 miles on it.

 

[av8er]

If it has a new motor at 1800 miles

and new pistons at 2000 miles, My math figures you had a new engine with 200 miles on it which you put new pistons in. why?????????

 

[philsummers21]

That is correct. Had the rktek pistons put in to replace the poorly fitting stock pistons. I wanted a reliable motor.

 

[philsummers21]

Will try to get new pictures today. realized that these pictures suck and dont do the sled any justice.

 

[philsummers21]

New pictures added. Taken today 4-7-13

 

[mfatty]

works

This sled is a ripper, it has always ran top notch

 

[philsummers21]

Would also consider trades on a RZR XP or XP4.

 

[philsummers21]

Sled is no longer for sale. Going to send the motor off to IndyDan and get the CMX belt drive.