Traction for Hill Climbs
- Thread starter plumnuts
- Start date
No more hillclimbs huh??? Can't use em on the tar can you?? 
I use the Kold Kutter traction screws out of WPS. ISR legal, I go with the 1.25". 151 finger track can easily hold 475-500 if you load it all the way up. That's my set-up right now. Heads will stay sharp for more than a few races, and that's even if you are racing a nasty course (like Jackson, Afton, etc...). I just screw them half way around when one side gets dull. Definetly want to put up some tunnel protectors too. Good luck man.
07
07
Does this mean you are back on for leading us into a new hillclimb organization??
Does this mean you are back on for leading us into a new hillclimb organization??
Plumnuts for President!!!.
Thanks guys, but no. Was excited about taking on the MSSHA challenge last summer but when Cory stated his desire to make MSSHA happen, we backed out and wish him all the success.... we re-focused on a different venue of racing, which will take a lot of our time starting April 1 through November.
Janet and I are looking at what we can do for the next ten-twenty years as we are both sunsetting our terrain racing "careers". THat being said, when you get a phone call and have the opportunity to destroy a $9K snowmobile in front of 10,000 screaming drunks, it is hard to say no.... thus the traction and race equipment for the XP
Janet and I are looking at what we can do for the next ten-twenty years as we are both sunsetting our terrain racing "careers". THat being said, when you get a phone call and have the opportunity to destroy a $9K snowmobile in front of 10,000 screaming drunks, it is hard to say no.... thus the traction and race equipment for the XP
You can be old and still run a hillclimb circuit, then you can one of the 10000 drunks.
