track extension

[khagge]

hi i know this question has been asked lot but i have a ski doo 700 that i have been modding for the past three years but just decided to dig deep in the rear skid but my question is since i am switching to a 159 track what skids will fit and what other limitations do i have i know i have to change the drivers do the tunnel and maybe other gearing. also i took out the starter does anyone know how to delete the ignition key?

thanks a lot

 

[Redsledhead]

What year sled? That will make a differance. I put a 159x2 on my 02 800 Summit and realy enjoy it. Depending on the track (Lug size and Pitch ) You might not have to change drivers. Not sure about the key

 

[khagge]

its a 2001 700 iam pretty sure i have to change the drivers

 

[Redsledhead]

I installed 3 19 tracks on 02&03 Summits and only changed 1 set of drivers (went anti stab on mine). Used the stock drivers on the other 2 sleds.
1-159 X2-1/8 x15
2-159 x 2 x15
3-159 x 2 x15
4- 156 x 2 x15
These are the tracks I used and stayed with the stock drivers on 3 of 4. If your going a deeper lug than you will need to change drivers or going to a different track pitch

 

[khagge]

what skid did u use or did u do extensions

 

[BU1]

Still need to know what sled you have to give logical suggestions.

 

[khagge]

2001 ski doo summit 700 it has a 144 track on it at the moment

 

[khagge]

does anyone have any ideas

 

[BU1]

3 1/2" skid setback and 4" rail extensions. Works good on pre - 02 Summits.

 

[sgtX]

on my '02 I did a 153' maverick and 7t drivers with 5' inch rail extensions and made my own two wheel kit and love it.
http://www.facebook.com/thisolsled
you can see it there

 

[khagge]

i would like to do a 159 skid no extensions with a 2 wheel kit on it, not gonna change the pitch or paddle height on the track i think i will gear down to a 7 tooth driver. what options do i have for a skid and track? can i use any of the rev platform skids??

 

[khagge]

any one got any ideas and i also got a couple more questions if i do change the drivers what tracks can i use with the 4 driver set up or how do i change it to the two driver set up and also when i change the track iam getting a 159 skid with a 8in big wheel kit do i put a 162 track on it or just cram the 159 in there

 

[khagge]

anyone got a answer