Track angle setup question

[CB-BLR]

When setting up your track angle on a ARO. With the bike sitting on a fairly flat surface...no dolly wheels.
Do most prefer the track to be parallel to the ground?
or do you like the rear of the track to be slightly up...reducing ski pressure?

I know this can be adjusted by either adjusting the strut/TSS length...or adjusting the fork height.

Trying to set up my new to me ARO 3

Chris

 

[eldereldo]

I don’t know about the ARO, but on the Camso they recommend the track to be level, but doing that makes the steering incredibly heavy, most people I know end up shortening the strut as much as they can, or even lowering the forks to lighten the front end. There is a point where it becomes really squirrelly on packed trails, so if you have to ride a long ways in you may have to accept a heavier ski pressure.

 

[ssblade]

I run mine flat knowing the TSS and the shocks are going to compress and give me that transfer when weighted. I found with the back of the skid lower, it put way too much ski pressure on the front and it handled like **** as well as trenching more.