TPS setting-voltage on CFI-2 vs CFI-4

[lognomore]

I know this has been discussed somewhere but can't find it. Are the TPS voltage on the 2011 pro the same as the IQ small blocks? 0.70 volts throttle plates closed, 0.93 volts idle setting? Also what is the resistance value of the tps? I have an extra tps that came off an 07 700 dragon that reads 4.6k ohms and the one on the pro reads 5.4k ohms. Did a tps check with an analog meter and both are good, no dead spots. Any help would be appreciated.

 

[AKSNOWRIDER]

this thread has the current settings for the cfi-2 pro motors...
http://www.snowestonline.com/forum/showthread.php?t=287858

 

[lognomore]

Thank you, Aksnowrider! Need to learn to find this stuff. I thought I was right with the settings. Had the clutch off, electronics plate off also so was a good time to check stuff out and silicon the wires going into the plug. Found after Polaris did the update on the oil hose the oil filter was rubbing on the throttle body, took off about a half inch of oil hose from the oil tank. Problem fixed. Everybody might want to check that out.