Torque specs 2010 assault?

[stuckassault]

So swapping rails and track and can't find any torque specs for anything. What about the driver and gear? Anything on the skid that needs specific torque specs? Any help would be great. Also buddy is doing the same on his 11 pro and we can't find anything on his sled either.

Thanks

 

[Polarisassault800]

just swapped mine over this week here are the specs

Chain case cover 10 FT LBS
Chain Case Drain Plug 10 FT LBS
Top Gear 50 FT LBS
Lower Gear 19 FT LBS
Rear Wheel shaft 35 FT LBS
Secondary Clutch if needed 17 FT LBS

 

[stuckassault]

Thanks for the info got everything swapped was waiting to adjust the track and tighten the lower gear tell I got some info. Looks like I know what I'm finishing up Saturday!

 

[PaulAnd]

TTT for me

 

[capnkirk]

just swapped mine over this week here are the specs

Chain case cover 10 FT LBS
Chain Case Drain Plug 10 FT LBS
Top Gear 50 FT LBS
Lower Gear 19 FT LBS
Rear Wheel shaft 35 FT LBS
Secondary Clutch if needed 17 FT LBS

shouldn't the lower gear be 50 also?? in fact a believe the manual says 49ft lbs.... both top and bottom. I will double check when I get home, as i have been known to mis-remember. lol

 

[PaulAnd]

Need top and bottom gear spec. for c3 install. Thanks guys!
2010 assault

 

[capnkirk]

shouldn't the lower gear be 50 also?? in fact a believe the manual says 49ft lbs.... both top and bottom. I will double check when I get home, as i have been known to mis-remember. lol

don't listen to this guy! lol... polarisassault800 is dead on.
lower gear fastner= 19 ft. lbs
upper gear castle nut= 50 ft. lbs

i will double check the numbers from now on, before i insert foot in mouth!

 

[PaulAnd]

ttt