Torque settings on the pro clutches?

[Pro-8250]

Can anyone tell me what to torque the bolt on the secondary (jack shaft) and primary (crank) clutch?

 

[Rev Kev]

Can anyone tell me what to torque the bolt on the secondary (jack shaft) and primary (crank) clutch?

Secondary is 17 ft lbs
Primary is 80 ft lbs

 

[Murph]

Drive 8o ft/lbs
Driven 17 ft/lbs

 

[AK800VE]

What is the tq setting for the cover on the primary...I am looking to change the spring

 

[Pro-8250]

Thanks on the torque setting. I am changing the spring on two secondary clutches. I got the helix back in on the first one but I am having a difficult time getting the helix back on to the second one. No matter what I do I am not having any luck with the second one. I do have the square part of the helix in the vise but I can't turn in clutch 100% of the way. The first one I was able to do by hand.

 

[Sixat38]

IIRC
The cover fasteners for the primary are 100 in.lbs.
The torx fasteners for the helix on the secondary are 60-80 in.lbs.
So both are basically... snug.

 

[Lorduss]

as long as we are on this subject, is it still a good pratice to torq down the primary after the first run?
how do you guys hold it still while you torq it?

 

[MURFDOG]

Yes it is and there is a clutch wrench for the p-85 to hold for removing and tightening.

 

[jdw1]

In the repair manual it says to torque it to 80 ft lbs and then run the engine and retorque, it doesn't say to what degree you run the engine before the retorque.

Fwiw.