i am rebuilding my 05 rev 800ho motor because of a broken piston. Anyways the question i have is that i only need to do the top but……..there is 1/2 inch missing out of the cylinder from the ring breaking on it. I was wondering if i should pull apart the bottom end to make sure that there is no metal sitting in it as well? or is there an easier way to do that?
the sled was ridden 20 miles on the one cylinder when the engine went so would all of the metal already shot out the exhaust or is it hanging out in the bottom end?
thanks for the help
the sled was ridden 20 miles on the one cylinder when the engine went so would all of the metal already shot out the exhaust or is it hanging out in the bottom end?
thanks for the help