Took my Pro hood off. Need help

[Mnt.Tamer]

I took my Pro hood off a few weeks ago for some chassis repair and I'm going to be putting it back together starting tomorrow and I can't remember how the hood fastens in the front? in the back you have the two bolts in front of the steering post, but the front???? any ideas?

 

[rrjames]

I usually line everything up in the rear and bolt it down then just pry the front end over. I went slow the first few times but its pretty easy.

Just be sure to line up the airbox inlet as to not damage its foam and you should be good to roll.

 

[Coleniuk]

Front

The front part clips into a plastic piece infront of the pipe, can't miss it! Check out the front inside and then thetop middle of the plastic infront of the pipe, you should be able to see how it clips in there!

 

[Mnt.Tamer]

Ok cool, thanks

 

[m1kflyingtiger]

http://m.youtube.com/watch?v=8YfuYXsRgEY

 

[FatDogX]

I usually line everything up in the rear and bolt it down then just pry the front end over. I went slow the first few times but its pretty easy.

Just be sure to line up the airbox inlet as to not damage its foam and you should be good to roll.

Pretty much says it all right here. It's crucial to run the two bolts in (3/4) by the bars first, then push / snap the front nose down. If you snap the front and then try and put the bolts in, it won't line up and you'll be using colorful words !! Just taking your time and making sure everything is lined up will save you time in the long run.

Also don't forget to plug your electrical connections back in when your done. I only bring it up because it's one of those little things you can get in a hurry and just forget about.

 

[trikerider]

There are a couple of tabs under each air intake that if installed properly makes the hood fit better at the rear. I didn't have them right until I did some work on my friends new 3013. When I went to take the hood off I noticed the two tabs.