Throttle Cable Issue

[Adam12]

Looking for a little advice. Installed the post forward kit and noticed the throttle cable was tightly routed around the front of the riser when swinging the bars back and forth. I disconnected the throttle cable from the flipper, rerouted the cable and reconnected it.

I just fired up the sled to load it in the trailer and I was getting a bog when trying to move it. I removed my riser bag and the throttle jumped to 3500 or so and remained at a high idle. I shut it down, fired it back up and with a hand firmly on the brake noticed the sled will rev when I move the cable itself. What did I break?

 

[Adam12]

I love posting here because I seem to figure it out the problem a few minutes later. I lost my throttle play because the end of the cable wasn't seated in the flipper properly. Little pressure from a pair of needle nose pliers and it popped into the detent. Figured I'll leave this here in case someone else makes the dumb mistake too.