tallest lug track for a 93 500 sks
- Thread starter Ryanlilly
- Start date
1 1/2 and even that was tight but it worked and thats all you really need for a 500
On my 90' 500 I ran a 2" that I cut down to 1.75". It did rub sometimes and only cleared the cooler by about 1/4". If I remember right I had to pull the chaincase to get the drive shaft in place then slide the case back in place. It was a PITA but did work well. If I did it again I'd go 1.5" or drop and roll.
I run 2" in my 93 Xlt. With 8 tooth drivers and an edge skid. And it barely clears. With 9 tooth drivers I would agree that 1.5" would be max. And I also have to take off my chaincase to pull the drivers, complete pain, but I run 4 drivers instead of 2 extroverts.
But I wanted to chime in so you know 2" is possible, just depends how far you wanna go.
Sorry if this doesn't make sense, typing on my phone is rough
But I wanted to chime in so you know 2" is possible, just depends how far you wanna go.
Sorry if this doesn't make sense, typing on my phone is rough
Last edited:
