Swapping steering post on 2010 M8

[Shift_Fast]

Try to remove the stock tele post and install a non tele post.

I have added the BDX anti slop kit to my stock tele post so I understand how to remove it most of the way. There is a stud at the bottom of the post and a nut threads onto that, where do I gain access to loosen the nut on that stud?

 

[GlennRMK]

Haven't swapped mine, but most likely you will need to remove the skid plate off the bottom so you can see the bottom of the engine. I think you can to it from there.

 

[mhanson]

its above the track driveshaft, no skidplate to remove.

 

[Nubulin]

The worst part is the "hoop" that you had to move to do the anti-slop thing. SInce you have done that, the only other thing is the linkeage bolt and the nut you take out under the tunnel in front of the track. A long extension and a swivel joint and its out in about 1 min.

I just did this on my 09 last week. I like the non adjust post a lot better.

 

[Shift_Fast]

OK thanks guys, looked up under and saw it, wish I had a sled lift. Guess my eye bolt in the garage beam and ratchet strap will have to work.

 

[hardcore2]

Lay it on its side